Department of Soft Water
Water Softener Installation in Oakville
White crust on taps, spotty glasses and a kettle full of scale. A softener takes the hardness out before it reaches your fixtures.
- Clear diagnosis before any cutting or replacing
- Price explained before the work starts
- Tested with water running before we leave
- Booked by phone, no forms
or ring (365) 399-5986Real people answer. Bookings by phone only.
- Licensed & insured (details on request)
- Oakville & Halton
- Phone bookings only
How a softener fits in
A water softener goes in on the incoming supply, downstream of the meter and shut-off, normally fitted with a bypass so it can be valved out for service. It holds resin that swaps hardness minerals for sodium or potassium. A brine tank beside it regenerates the resin on a schedule. The unit needs a drain for the regeneration water and a standard electrical outlet.
Job sheet: Water Softener Installation in Oakville
- Where we get in
- Main line just after the meter and main valve
- On the van
- Softener, bypass valve, PEX or copper, drain line, air gap fitting
- Before we pack up
- Hardness tested before and after regeneration
- How to book
- Phone only: (365) 399-5986
Hardness in Halton
Oakville's municipal water is drawn mainly from Lake Ontario and is moderately hard. Some nearby communities on well water are harder still. Read our hard water guide for what that means at the tap, and check the Region's published water quality reports for current figures.
Signs you need this now
- Scale on faucets and showerheads
- Spotty dishes
- Kettle crusting quickly
- Water heater rumbling with sediment
- Dry skin after showers
Decide these points first
- Where in the basement the line can be cut in, with room for both tanks.
- Whether an outside tap should stay on hard water for the garden.
- Whether a drinking water filter will be added at the kitchen sink.
See choosing a water softener for sizing and salt-versus-salt-free questions.
The visit in five steps
- 1Test water hardness
- 2Cut into the main and fit a bypass
- 3Connect inlet and outlet
- 4Run drain line with an air gap
- 5Program and start the softener
The installation
We cut into the main line, add the bypass, set the tanks, run a drain line with an air gap and program the unit for your family size and water hardness. We then run water until the softened supply reaches the far fixtures and test it.
Pairs well with
A filtration system for taste and chlorine, and tankless descaling if scale has already built up.
Straight answers to common calls
Will softened water taste briny?
Most people do not notice. Some install a separate drinking water tap.
Does a softener need much upkeep?
Topping up salt and an occasional look at of the brine tank cover most of it.
Keep reading
- Water Filtration Systems in Oakville
Municipal water in Oakville is treated and tested.
- Living with Hard Water in Halton
White crust on the tap.
- Tankless Water Heater Installation in Oakville
No tank in the corner, heat only when a tap opens.
Ready when you are
One call books the visit. Tell us what you are seeing and we will tell you straight what it likely is.